Initial Testing, Notes & Progress on new PCB for Wireless Audio Prototyping

 Initial Testing, Notes & Progress on new PCB for Wireless Audio Prototyping

 Testing out the new circuit boards and getting the built-in microphone working

 If you weren't following along I just received some new custom built circuit boards from PCBWay.com and have been testing things out extensively. Everything works! I even got the custom-added I2S microphone working with the nRF52840.

                                            The new circuit board with an old external speaker

Getting the Microphone working with the AutoAnalogAudio library: 

The nRF52840 Feather Express/Sense does have an I2S interface, but it only supports up to a 24-bit window, whereas the SPH0645LM4H expects 32 SCK pulses per audio frame (18 bits of data + 14 bits of padding) and a 64 x BCK signal, where the nRF52840 typically does a 48 x BCK signal.

After a bit of searching, I found that the appropriate signal could be created by the PWM peripheral of the 52840, and the I2S interface would just need to be configured with special settings to grab the 18-bits of data properly.

The main drawback with using this mode is the I2S interface can only operate in either Input or Output mode, they can't be run at the same time unless both I2S Input & Output devices use the same settings. I had to make some modifications to the AutoAnalogAudio library, released in v1.54.0, in order to allow switching between I2S modes.

Currently, this mode is only supported for input devices. 

                                                                The Feather Express 52840 

Configuration for the Microphone: 

To use the new special settings, users need to set the aaAudio.manualI2S variable to True before calling the aaAudio.begin(2,0); function.

With the Feather Express, the LRCK or WS pin needs to be configured from the default of 29, to something like 28, which is A3 on the Feather Express 52840

Results: 

 I've put together a full Radio Transceiver example for this PCB, found at https://github.com/TMRh20/FeatherAudio/tree/main/Examples/I2S_TransmitterAndReceiver

In order to use the example, upload to two Feather 52840 Express or Sense boards, and plug them into the custom PCB, or manually attach external I2S microphone & amplifier.  

The example features 3 buttons, the PTT button is used to transmit, then there are two for Volume Up/Down. If users press and hold Volume Down, then Press Volume Up, the device will go into a continuous transmission mode, not requiring the PTT button to be pressed.

The device also toggles the onboard red LED when data is received.

 Audio is relatively high quality at 16-bits and 32kHz, so it is pretty clear and useful for many different applications.